Initialization; Default Settings - Epson ActionPrinter 2000 User Manual

Initialization

There are two ways that the printer can be initialized (returned to
a fixed set of conditions).
Hardware initialization
Software initialization

Default settings

The table below shows the default conditions that become
effective
when
Item
Too of form position
Page length
Left and right margins
Line spacing
Vertical tab position
Horizontal tab positions
Font selection
Special printing effects
In addition, hardware initialization clears the data buffer of all
text.
Technical Specification
7-10
the printer is initialized.
• The power is turned on.
• The printer receives an INIT signal from
the parallel interface (pin 31 goes LOW).
• Software sends the ESC @ (Initialize the
printer) command.
Default condition
Current paper position
The current DIP-switch setting
Canceled
1/6 inch
Cleared
Every eight characters
The current SelecType setting
Canceled
Hardware: cleared
Software: deselected only