Adjusting The Loading Position - Epson ActionPrinter 2000 User Manual

Adjusting the Loading Position

The loading position is the point where the paper stops when you
load paper using the
because it determines where the printing begins on the page. If the
printing is too high or too low on the page, change the loading
position using the micro-adjustment feature as described below.
CAUTION: Never use the platen knob to feed paper
after turning on the printer. (If you need to use the
adjust the loading position, always use the following
1. Make sure that the printer is turned on and that paper (single
sheet or continuous) is ready for loading.
2. Press the
LOAD/EJECT
position. Then press and hold down the
the beeper sounds once and the
3. Press
the FORM FEED
LINE FEED
set the desired loading position, you
light automatically stops blinking.
LINE
Note: You
can
adjust the loading position only while the
blinking.
LOAD/EJECT
button to feed paper to the loading
button to feed the paper forward or the
button to feed the paper backward. When you
use the
FORM FEED
button. This position is important
ON LINE
light begins to blink.
ON LINE
begin printing; the
can
and
LINE FEED
ON LINE
Paper Handling 2-7
button until
have
ON
buttons to
light is