Husqvarna DM 540i Operator's Manual page 15

®
Bluetooth wireless technology
Products with built-in Bluetooth
can connect to mobile devices and enables additional
functions from HUSQVARNA connect.
Bluetooth
The symbol for
on when your mobile device is connected to the product.
(Fig. 7)
To use embedded connectivity with
fleet
Note:
This part is applicable only for products
supplied with embedded connectivity.
Note:
Radio transmission by the Bluetooth
will be enabled on the first time of connection to a
battery, and stay on after that.
1. Download the Husqvarna Fleet Services iOS or
Android app Husqvarna Fleet Services.
2. Go to Husqvarna Fleet Services website https://
fleetservices.husqvarna.com for more information.
To connect the battery charger
1. Connect the battery charger to the voltage and
frequency that is specified on the rating plate.
2. Put the plug in a grounded socket outlet. The LED
on the battery charger flashes green one time.
Note:
The battery does not charge if the battery
temperature is more than 50 °C/122 °F. If the
temperature is more than 50 °C/122 °F, the battery
charger makes the battery become cool before the
battery charges.
To connect the battery to the battery
charger
Note:
Charge the battery if it is the first time that you
use it. A new battery is only 30% charged.
1. Make sure that the battery is dry.
2. Put the battery in the battery charger. (Fig. 17)
3. Make sure that the green charging light on the
battery charger comes on. That means that the
battery is connected correctly to the battery charger.
(Fig. 18)
4. When all LEDs on the battery come on, the battery is
fully charged. (Fig. 19)
5. To disconnect the battery charger from the mains
socket, pull the plug. Do not pull the cable.
6. Remove the battery from the battery charger.
1567 - 001 - 21.06.2021
®
wireless technology
®
wireless technology comes
®
function
Note:
Refer to the battery and battery charger
manuals for more information.
To use the auxiliary handle
(Fig. 20)
1. Turn the handle counterclockwise to release it.
2. Move the handle around the spindle shaft to an
applicable operation position.
3. Turn the handle clockwise to lock it. Tighten fully.
To use the product handheld
WARNING:
from a ladder. If the drill bit becomes
blocked, there is a high risk of fall injury.
(Fig. 21)
1. Always use a drill bit with a maximum diameter of 75
mm with handheld drill operation.
Operation
Handheld
Drill stand
WARNING:
blocked, a reaction will occur. Larger
diameter of the drill bit gives larger
reaction.
2. Lock the auxiliary handle tightly in position before
you operate the product. Refer to
auxiliary handle on page 15 .
To prepare the product for dry drilling
WARNING:
drill, which can cause injuries if breathed in.
Use approved breathing protection.
WARNING:
vacuum cleaner. Use only designated dust
extractors for hazardous dust. Refer to
extractor on page 22 for minimum
properties.
1. Attach the dust extractor connector to the mounting
thread on the product.
2. Attach the dust extractor to the dust extractor
connector. (Fig. 22)
3. Start the dust extractor.
Do not operate the product
Drill bit diameter, mm
25-75
25-100
If the drill bit becomes
To use the
Dust is made when you
Do not use a house-hold
Dust
15