Replacing The Rear Connector/Interface Pcb Assembly - Philips FM-2 Service Manual

Replacing the Rear Connector/Interface PCB Assembly

Chapter 6 - Disassembly/Reassembly Guide
Step 1. Place the rear connector/interface PCB assembly into the dedicated
recess inside the rear case assembly. See that the RS-232, parallel and
power supply connectors fit into their respective slots in the rear case.
Step 2. From outside the rear case, use a 3/16 socket driver to refit the two
standoff fasteners of the RS-232 connector, and the two standoff
fasteners of the parallel port to secure the rear connector PCB in place.
Step 3. Ensure that the speaker cable connector is secure on the interface PCB.
Check that the two pins on the board are perpendicular to the board,
or leaning slightly towards the connector latch. This will ensure a firm
connection.
Step 4. Route the cables for the speaker and the battery.
Rear Case Disassembly Procedures
Speaker cable connector
Connector latch
57