Table of Contents
Advertisement
Internal I/O Connectors
Expansion Slots
X
X
PCIE1 (PCIe x16)
PCI1 (PCI)
PCIE3 (PCIe x4)
PCIE4 (PCIe x4)
PCI Express x16 Slot
Install a PCI Express x16 graphics card that complies to the PCI Express specifications into the
PCI Express x16 slot. To install a graphics card into the x16 slot, align the graphics card to the
socket and perpendicularly to the board, be cautious in aligning the locations of notch and key,
and then press the card down firmly until it is completely seated. The retaining clip of the slot
will close up automatically to hold the graphics card in place.
PCI Express x4 Slot
Install PCI Express cards such as network cards or other cards that comply to the PCI Express
specifications into the PCI Express x4 slot.
PCI Slot
The two PCI slots support expansion cards that comply with PCI specifications. You can install
a PCI expansion card or a customized riser card designed for only 2 PCI slots expansion (for
low profile PCI card only) into the PCI slot.
M.2 Socket
The M.2 socket is the Next Generation Form Factor (NGFF) which is designed to support mul-
tiple modules and make the M.2 more suitable in application for solid-state storage. The board
preserves two form factor stand-offs for the M.2 M key socket, allowing a 22mm x 42mm or a
22mm x 80mm M.2 module to fit onto the board.
User's Manual | CS332
Internal I/O Connectors
X
Installing the M.2 Module
Before installing the M.2 module into the M.2 socket, please make sure that the following
safety cautions are well-attended.
1. Make sure the PC and all other peripheral devices connected to it has been powered
down.
2. Disconnect all power cords and cables.
3. Locate the M.2 socket on the system board
4. Make sure the notch on card is aligned to the key on the socket.
5. Make sure the standoff screw is removed from the standoff.
M.2 M Key
(2242/2280)
M.2 E Key
(2230)
HARDWARE INSTALLATION
Expansion Slots
X
M.2 Module
Stand-off
Notch
Chapter 2
M.2 Socket
Key
27
Advertisement
Table of Contents
