Internal I/O Connectors
X
Front Panel
Front Panel Pin Assignment
Pin
Assignment
1
N.C.
3
HDD Power
HD-LED
5
Signal
7
Ground
RESET
9
Signal
11
N.C.
HDD-LED - Hard Disk Drive LED
Lighting of the LED indicates that the hard drive is being accessed.
RESET - Reset Switch
This switch allows you to reboot without having to power off the system.
PWR-LED - Power/Standby LED
When the system's power is on, this LED will light up. When the system is in the S1 (POS -
Power On Suspend) state, it will blink at 1-second intervals. When the system is in the S3 (STR
- Suspend To RAM) state, it will blink at 4-second intervals.
ATX-SW - ATX Power Switch
This switch is used to power on or off the system.
User's Manual | CS332
1
2
PWR-LED
HD-LED
ATX-SW
RESET
11 12
Front Panel Connector
Pin
Assignment
2
LED Power
PWR-LED
4
LED Power
6
Signal
8
Ground
ATX-SW
10
Signal
12
---
Internal I/O Connectors
X
Chassis Intrusion
Chassis Intrusion
1
The board supports the chassis intrusion detection function. Connect the chassis intrusion
sensor cable from the chassis to this connector. When the system's power is on and a chassis
intrusion occurred, an alarm will sound. When the system's power is off and a chassis intrusion
occurred, the alarm will sound only when the system restarts.
Chassis Intrusion Pin Assignment
Pin
Assignment
1
Signal
Chapter 2
HARDWARE INSTALLATION
Pin
Assignment
2
GND
22