Setting the current operating mode
A setting change at this point only affects a change to the operating mode
until the next change-over initiated by the timer program.
Operating modes of heat pump/heating circuit:
"Standard" The heat pump/heating circuit will be regulated to the standard
temperature.
"Off"
The heating circuit is switched off. The heat pump will only be
activated for heating DHW (if set) and to protect the system
against frost.
"Reduced"
The heat pump/heating circuit will be regulated to the reduced
temperature.
"Fixed value Only for systems with a heating water buffer storage unit:
regulator"
The storage unit will be heated independent of outside
temperature to the fixed value set by your specialist
(e.g. during low tariff times).
Press the following keys:
1.
for "Program".
C
2.
A
for "Heat pump"
or
for "Mixer 1".
C
The "Current operating
mode" is highlighted.
Heat pump 1
Current operating mode : Standard
Standard temperature
Reduced temperature
Timer/switching times
Too warm/too cold
>>
±
°
>>
<<
3.
/
until the required
operating mode appears.
4.
BACK
to confirm.
:
20.0
:
16.0
<<
BACK
STANDA
Heat pump/heating circuit settings
13