Terminals - Eiki EK-110U Owner's Manual

Terminals

① AUDIO OUT
Connect external audio amplifier to this jack.
② MONO(R/L)
For a mono audio signal (a single audio
jack), connect it to MONO(R/L) jack.
③ VIDEO IN
This is the terminal to input video signals.
④ VGA IN 2/VGA OUT
- Connect a computer output to this terminal.
- Output the analog signal form ② to other
monitor.
⑤ HDMI / MHL
This is the terminal to input the HDMI or MHL
signals.
⑥ HDMI
This is the terminal to input HDMI signals.
⑦ USB-A
When using the "Memory Viewer" function,
insert the USB memory directly to this
terminal.(Refer to Page 51)
⑧ USB-B
This terminal is used to connect the
projector to the computer with a USB cable
when you want to use the "USB Display"
function.(Refer to Page 63)
10
Part names and functions
① ② ③ ④
VGA IN 2 / VGA OUT
AUDIO
VIDEO IN
R L
OUT
RS-232C VGA IN 1 / YPbPr / S-VIDEO IN
AUDIO IN
⑩ ⑪ ⑫
⑤ ⑥ ⑦
HDMI/ USB-A
MHL
HDMI
⑬ ⑭
⑨ LAN
- This is the LAN terminal to connect to the
network.
- Connect the projector to the computer via
RJ45 cable when you use the "Network"
Display function.
⑩ AUDIO IN
This is the terminal to input computer audio
signals.
⑪ RS-232C
When using RS232 to control the projector,
please connect the serial control line to this
terminal.
⑫ VGA IN 1/YCbCr/S-VIDEO IN
This is the terminal to input RGB, YCbCr or
S-video signals.
⑬ Remote Control receiver(BACK)
Operation the projector by remote control.
⑭ Kensington Security Slot
This slot is for a Kensington lock used to
deter theft of the projector.
* Kensington is a registered trademark of
ACCO Brands Corporation
⑧ ⑨
LAN
USB-B