Installing The Module Into The Smartswitch 9000 Chassis - Cabletron Systems 9F241-12 User Manual

Microlan dual attached concentrator module

Hide thumbs Also See for 9F241-12:

Table of Contents

Installing the Module into the SmartSwitch 9000

Chassis

SmartSwitch 9000 MicroLAN Modules can be installed in any of the 14 slots that

are available. To install, follow the steps below:

1. Switch off the power supplies and remove all power from the SmartSwitch

9000 chassis.

2. Remove the blank panels, covering the slots that the module is being mounted

in. All other slots must be covered, if modules are not being installed, to

ensure proper airﬂow and cooling.

3. Attach one end of the ESD wrist strap packaged with the SmartSwitch 9000

chassis to your wrist. Plug the other end into the ESD Wrist Strap Grounding

receptacle in the lower right corner of the SmartSwitch 9000 Chassis shown in

Figure 2-3.

4. Slide the module into a slot and lock down both the top and bottom plastic

tabs, as shown in Figure 2-3. Take care that the module slides in straight and

engages the backplane connectors properly.

Installing the MicroLAN Module

2-5

Table of Contents

Smartswitch 9000