Chapter 2 Getting Started; Terminal Configuration; Vt100 Series Setup - Cabletron Systems IRM/LM User Manual

This chapter lists procedures for entering the password so you can access
Local Management for the IRM. It also provides the terminal and cable
configurations for setting up a terminal for accessing Local Management.
Instructions are included for exiting Local Management.
2.1

TERMINAL CONFIGURATION

Local Management for the IRM is accessed through a VT™ 100 Series
terminal, a Prime™ 200 Series terminal, or a compatible system running
an emulation program. The terminal is attached to the port labeled
CONSOLE on the IRM by an RS-232 cable. For instructions to set up
your terminal, refer to the applicable node user's manual.
The terminal configurations must be set as follows so the terminal can
communicate with Local Management.
2.1.1

VT100 Series Setup

If you have a VT100 series terminal, press F3 to access the Setup
Directory.
Display Set-up Menu
Columns
Controls
Auto Wrap
Text Cursor
General Set-up Menu
Mode
Cursor Keys
CHAPTER 2
GETTING STARTED
80 Columns
Interpret Controls
No Auto Wrap
No Cursor
(VT220) VT200, 7 Bit Control
(VT320) VT300, 7 Bit Control
Normal Cursor Keys
2-1