Table of Contents
Advertisement
9 Pin Male Connector
(IRM2 End)
Pin 3 (Receive)
Pin 2 (Transmit)
Pin 5 (Ground)
Pin 7 (Request to Send)
Pin 8 (Clear to Send)
2.1.3
Accessing Local Management
This procedure assumes that a 9 to 25 pin RS232 cable is connecting the
terminal to the IRM2.
To access Local Management:
1. Plug the 9 pin end of the RS232 cable into the RS232 port labeled
CONSOLE on the IRM2.
2. Plug the 25 pin end of the RS232 cable into the COMM port on the
terminal.
3. Turn the terminal on. The IRM2 Password Screen will appear.
4. Enter your Password. (The factory default password is the Return
key).
Note: If you enter a Superuser name at the Community Names Screen (see
Chapter 4), the password becomes the Superuser name. If you enter more
than one Superuser name, you may use any of these names as the
password.
5. Press Return. The IRM2 SNMP Local Management Screen, Figure
2-1, appears on the terminal.
6. Use your arrow keys to select the MAIN option at the bottom of the
screen and press Return. The DEVICE/BOARD/PORT COUNTERS
Screen, Figure 2-2, appears.
You may now use IRM2 Local Management.
to
9 Pin Female Connector
(Terminal End)
to
Pin 3 (Transmit)
to
Pin 2 (Receive)
to
Pin 5 (Ground)
to
Pin 8 (Clear to Send)
to
Pin 7 (Return to Send)
GETTING STARTED
2-3
Advertisement
Table of Contents
