Table Of Contents - Cabletron Systems IRM-2/LM User Manual

CHAPTER 1
1.1 USING THIS MANUAL ................................................................ 1-1
1.2 GETTING HELP .......................................................................... 1-2
1.3 ABOUT IRM2 LOCAL MANAGEMENT ....................................... 1-2
1.4 RELATED MANUALS.................................................................. 1-3
1.5 SUGGESTED READING............................................................. 1-3
CHAPTER 2
2.1 LOCAL MANAGEMENT FROM A TERMINAL............................ 2-1
2.1.1 Terminal Configurations.................................................. 2-1
2.1.2 Cable Configuration ........................................................ 2-2
2.1.3 Accessing Local Management ........................................ 2-3
2.2 LOCAL MANAGEMENT THROUGH A MODEM......................... 2-5
2.2.1 Cable Configuration ........................................................ 2-5
2.2.2 Accessing Local Management ........................................ 2-5
CHAPTER 3
3.1 DEVICE/BOARD/PORT COUNTERS SCREEN ......................... 3-1
3.1.1 Displaying the Desired Board/Port.................................. 3-2
3.1.2 Device/Board/Port/Counters Screen Fields .................... 3-3
3.1.3 Using the Reset Counters Option ................................... 3-4
3.1.4 Using the Enable Board/Disable Board Option............... 3-4
3.1.5 Using the Enable Port/Disable Port Option..................... 3-5
3.1.6 Using the Enable All Ports Option .................................. 3-5
3.2 OTHER COMMAND OPTIONS................................................... 3-5
CHAPTER 4
4.1 COMMUNITY NAMES SCREEN................................................. 4-1
4.1.1 Community Names Screen Fields .................................. 4-2
4.1.2 Editing the Community Names Screen ........................... 4-3
CHAPTER 5
5.1 SETUP SCREEN......................................................................... 5-1
5.1.1 Setup Screen Fields ....................................................... 5-2
5.1.2 Changing the Device Name ............................................ 5-3
5.1.3 Using the Set IP Address Option .................................... 5-3
5.1.4 Using the Set SubNet Mask Option ................................ 5-4
5.1.5 Using the Set Default Gateway Option ........................... 5-5
CONTENTS
INTRODUCTION
GETTING STARTED
DEVICE/BOARD/PORT COUNTERS
USING THE COMMUNITY NAMES OPTION
USING THE SETUP OPTION
iii