Error Log Codes - Welbilt Frymaster FilterQuick easyTouch Installation, Operation And Maintenance Manual

6.2.5

Error Log Codes

See section 1.12.2.1 in the FilterQuick™ easyTouch
access the Error Log.
Code
E13 TEMPERATURE PROBE FAILURE
E16 HIGH LIMIT 1 EXCEEDED
E17 HIGH LIMIT 2 EXCEEDED
E18 HIGH LIMIT PROBLEM
DISCONNECT POWER
E19 HEATING FAILURE – XXX F or XXX C
E25 HEATING FAILURE - BLOWER
E27 HEATING FAILURE - PRESSURE SWITCH - CALL
SERVICE
E28 HEATING FAILURE – XXX F or XXX C
E29 TOP OFF PROBE FAILURE - CALL SERVICE
E32 DRAIN VALVE NOT OPEN - FILTRATION AND TOP
OFF DISABLED - CALL SERVICE
E33 DRAIN VALVE NOT CLOSED - FILTRATION AND
TOP OFF DISABLED - CALL SERVICE
E34 RETURN VALVE NOT OPEN - FILTRATION AND
TOP OFF DISABLED - CALL SERVICE
E35 RETURN VALVE NOT CLOSED - FILTRATION AND
TOP OFF DISABLED - CALL SERVICE
E36 VALVE INTERFACE BOARD FAILURE - FILTRATION
AND TOP OFF DISABLED - CALL SERVICE
E37 AUTOMATIC INTERMITTENT FILTRATION PROBE
FAILURE - FILTRATION DISABLED - CALL SERVICE
E39 CHANGE FILTER PAD
E41 OIL IN PAN ERROR
E42 CLOGGED DRAIN (Gas)
E43 OIL SENSOR FAILURE - CALL SERVICE
E44 RECOVERY FAULT
E45 RECOVERY FAULT – CALL SERVICE
E46 SYSTEM INTERFACE BOARD 1 MISSING - CALL
SERVICE
E51 DUPLICATE BOARD ID - CALL SERVICE
E52 USER INTERFACE CONTROLLER ERROR - CALL
SERVICE
E53 CAN BUS ERROR - CALL SERVICE
ERROR MESSAGE
® Segmented Controller Manual for instructions to
TEMP Probe reading out of range
High limit temperature is past more than
410°F (210°C), or in CE countries, 395°F
(202°C)
High limit switch has opened.
Vat temperature exceeds 460°F (238°C) and
the high limit has failed to open. Immediately
disconnect power to the fryer and call service.
Heating Control latch circuit failed.
Heat Contactor failed to latch.
The air pressure switch(s) failed to close.
The air pressure switch has failed closed.
The fryer has failed to ignite and has locked
out the ignition module.
ATO RTD reading out of range
Drain valve
confirmation is missing
Drain valve
confirmation is missing
Return valve was trying to open and
confirmation is missing
Return valve was trying to close and
confirmation is missing
Valve Interface Board connections lost or
board failure.
AIF RTD reading out of range.
25-hour timer has expired or dirty filter logic
has activated.
The system detects that oil may be present in
the filter pan.
Vat did not empty during filtration
Oil level sensor may have failed.
Recovery time exceeded maximum time limit.
Recovery time exceeded maximum time limit
for two or more cycles.
SIB board 1 connection lost or board failure.
Two or more controllers have the same
location ID.
The controller has an unknown error.
Communications are lost between boards.
6-7
EXPLANATION
was trying to open
was trying to close
and
and