Start Reminder; Retrieval - Youcan Robot BW Space User Manual

If the system prompts that the device is not found, try the following:
（ 1 ） Tighten the connector until you hear a light and short sound of beep.
（ 2 ） Try to disconnect the tether and device (including the drone and WiFi
Repeater) multiple times, and reconnect the APP until the device is successfully
searched.
If all of the above steps fail, please contact our after-sales team ： service@
youcanrobot.com
4.Put the BW Space into water.

Start Reminder

Open the Youcan Dive APP when the tether is connected to BW Space and
WiFi Repeater, and BW Space will flash three times, indicating the APP is
successfully connected, ready for operation.
In case of start failure, check the following things:
(1) If the device is appropriately powered;
(2) If the jack of the tether is connected to BW Space or WiFi Repeater jack
appropriately;
(3) Open the Youcan Dive APP and check to see if the device is connected. If
the connection fails, reconnect the WiFi Repeater.
Note: After the tether is successfully connected to the BW Space, it will
play a light and short music, which indicates that BW Space is started. It is
normal to find that after the APP is connected, if BW Space is not put into the
water for a long time, BW Space will make a sound of tick, tick ...

Retrieval

After using, you can steer the BW Space back to the shore or to boat, pull back
the tether and drag the drone out of the water.
Note: Before BW Space is placed in the water, make sure the tether is
securely connected to facilitate the retrieval after using.
08