Youcan Robot BW Space User Manual page 10

Cautions: plugging and unplugging
of 4-pin connector
1.Before installing the connector,
please apply the sealing lubricant to the
sealing ring and screw thread (see the
package and Page25 for how to use it).
2.When plugging the connector,
align the jack and turn the nut until
it is tightened; when unplugging the
connector, unscrew the nut until it can
be pulled off.
3.Please make sure that the jacks are
aligned with each other.
4.It is prohibited to touch the connector
front end with wet or sweaty hands;
water should be dried if there is water
on the connector.
5.It is not allowed to drag or pull the
connector lest the connector or tether is
broken.
6.Tighten the screws or fasteners with your fingers. Do not tighten the screws
with pliers or other tools when installing lest the connector is damaged or
broken.
05
WiFi Repeater charging
The light is yellow when
charging and turns green
when the charging is
completed.
If the light is red, the device failed
to connect successfully. Please
tighten the connector.
The red light flashes continuously,
idicating that the device may be
faulty. Try to replace the device
(drone or WiFi Repeater) for
charging, or exchange the connector
of the cable.
If all of the above steps fail, please
contact our after-sales team ：
service@youcanrobot.com 。