Powering Up Power Supplies - Cabletron Systems 9C500 Plus Installation Manual

Powering Up Power Supplies

If necessary, before performing the power up steps, refer to the SmartSwitch 9000
9C214-1 AC Power Supply Installation Guide or the SmartSwitch 9000 9C214-2
DC Power Supply Installation Guide for detailed information regarding
connecting a power supply to the power source.
After installing the power supply(ies) (and attaching the terminator if necessary)
power up the power supply(ies) by following the steps below:
1. Plug the power cord into the power source (AC receptacle or DC power
source). Turn on the power supply using the switch located near the power
cord. The power supply uses a soft start feature and does a pre-power
diagnostic check. Outputs become enabled within five seconds of power on.
Slide this end in
toward front of
chassis
100-125v-12A
200-250v-6A
50-60 Hz
2
100-125v-12A
200-250v-6A
50-60 Hz
Figure 1-2. Installing Power Supply (Supplies)
Installing the 9C500 Plus Power Box
1
100-125v-12A
200-250v-6A
50-60 Hz
1-7