Measuring With An Id Number (Call Measurement) - Tanita InnerScan Pro RD-545PRO Instruction Manual

Measuring with an ID Number
Enter your ID number and take measurements without using auto-recognition. Use this method if using auto-recognition repeatedly
causes the device to switch to ID select mode, etc.
Place the body composition monitor on a hard, flat, stable floor.
1.Press to turn on the power without removing the control panel from the device.
2.After is displayed, press
3.Select your ID number using the
4.Press to confirm.
5.After is displayed, remove the control panel from the device and carefully
step barefoot onto the measuring platform.
Note:
・Please refrain from moving during measurement.
・Measurements cannot be taken accurately if the control panel is being held or
resting on the floor before is
6.Step off the measuring platform when you hear it beep.
The device automatically turns off after measurement results have been displayed.
When you are finished reviewing your measurements, return the control panel to its
original position.
Note:
・If you have entered a nickname into the app settings and connected the body
composition monitor to your smartphone, your nickname is displayed instead of
your ID number.
・If you step onto the measuring platform before
is displayed and the power turns off during measurement.
.
and buttons.
is displayed.
is displayed,
(Call Measurement)
or
en
15