Tanita InnerScan Pro RD-545PRO Instruction Manual page 5

en
Place the monitor on a hard, flat surface where there is minimal vibration to ensure safe and accurate measurement.
Avoid excessive impact or vibration to the monitor.
Doing so may damage the monitor or cause it to malfunction,or may cause setting to be erased.
Do not use or store this monitor in the following locations.
·Locations that are exposed to direct sunlight, near to heaters, or exposed directly to air from air conditioning units, etc.
·Locations where there are severe temperature changes or a large amount of vibration.
·Locations with high levels of humidity or moisture
Doing so may damage the monitor or cause it to malfunction.
Do not step on the monitor when your body is wet (immediately after a shower or bath, etc.)
Be sure to thoroughly dry your body and feet before using the monitor. Failure to do so may cause you to slip or fall,
resulting in injury. Also, the monitor cannot take accurate measurements if your body or feet are wet.
Keep away from water.
Do not use boiling water, benzene, thinner or alcohol, etc. to clean the monitor.
If the monitor becomes dirty, soak a soft cloth in water or neutral household detergent, wring it out thoroughly and
wipe the monitor clean, then use a dry cloth to wipe the monitor dry.
Do not attempt to disassemble the monitor. Do not modify this equipment in any way.
Do not wash the monitor in water.
Do not submerge this monitor in water.
Doing so may damage the monitor or cause it to malfunction.
Be sure to insert the batteries with the polarities (+, -) in the correct position.
If the batteries are incorrectly inserted, battery fluid may leak and damage the floor. (If you do not intend to use this
monitor for a long period of time, it is advisable to remove the batteries before storage.)
Do not use the monitor near other products such as microwave ovens that emit electromagnetic waves.
Doing so may cause the monitor to malfunction, preventing accurate measurements.
Another person should assist persons with disabilities who may not be able to take a measurement alone.
Always... Avoid measuring after over-eating or over-drinking, or when severely dehydrated.
This may cause inaccurate measurements. For greater accuracy, avoid using directly after waking up.
Use at the same time of day each time, at least two hours after the last meal.
Avoid taking measurements after spending time in a sauna, bath or after intense exercise.
This may cause inaccurate measurements. Please take measurements after sufficient rest.
Avoid taking measurements when your physical condition is poor (hangover, diarrhea, fever, etc.).
Doing so may cause error in the measured value. Resume measuring once you have recovered.
Perform measurement with as little clothing on as possible.
Weight of clothing worn will be included in measurements.
Be sure that your toes and heels are correctly aligned with the electrodes on the measurement platform.
The body fat percentage displayed may be low or result in an " " (error) display if contact between the
electrodes and the soles of the feet is poor.
If you do not undress, always remove your socks or stockings,and be sure the soles of your feet are clean
before stepping on the measuring platform.
Use in a stable location. Errors in measurements may occur if the device is used in an unstable location.
An accurate reading will not be possible if your knees are bent or you are in a sitting position.
Do not move during measurement.
This causes inaccurate measurements.
Ensure arms are not touching sides and inner thighs are not touching each other during measurement.
If necessary, place a dry towel between arm and side and/or between thighs.
5