Desktop Installation
Desktop Installation
To install the Access Point on a desktop, do the following:
1. Make sure the site primary power for the AP conforms to the specifications detailed in
Chapter 2
2. Select a desktop location:
— If using remote power, close to the 10BaseT Ethernet network cable connector.
— If not using remote power, within five feet of an AC electrical outlet:
3. Remove the mounting bracket from the AP:
— Completely loosen the captive screw.
— Slide the bracket until the two screw slots are directly below the two shoulder
mounting screws.
— Lift and remove the bracket from the AP.
3-14 Installing the Access Point
- Cabling and Wiring.
a) If using redundant power (connecting both local power and remote
power).
or
b) If using the local power option and not using the remote power option.