Enterasys RoamAbout AP-2000 Hardware Installation Manual page 52

Verifying the Operation of the Access Point
Table 3-2: Access Point LED Patterns
Wired Wireless
LAN LAN
= On
3-24 Installing the Access Point
Access Bridge
Point State
Saturated
2
= Off = Constant blinking
Power/ Meaning of LED
System Pattern
OK
No power. Check the power
connections.
Diagnostics failed. The AP
automatically resets after one
minute. If the pattern
continues to display, contact
technical support.
Normal operating mode.
AP is waiting for the
spanning tree. No action is
required. Or, Spanning Tree
detected a bridge loop and
disconnected the port.
Remove the loop.
AP is occasionally saturated.
No action is required.
Cannot communicate with
the wireless network. Verify
that the PC Card is properly
inserted.
Cannot communicate with
the wired network. Verify
that the Ethernet cable is
properly connected.
Cannot communicate with
the wireless or wired
network.
= Random blinking