Chapter 3
Installing the Access Point
This chapter provides the procedures to install the Access Point 2000 and its options.
Make sure the site primary power for the AP conforms to the specifications detailed in
Chapter
2.
If using a BootP/TFTP server and the AP Manager to configure the APs with IP addresses,
you should configure the server BEFORE applying power to each AP. Upon power-up,
each AP automatically sends a BootP request.
If you plan to use the AP Manager program, write down the MAC address listed on the front
of the AP. For a LAN-to-LAN configuration, also write down the MAC address on the back
of the PC Card, which is the wireless MAC address.
Installing the Access Point 3-1