Recharging Batteries - Challenge CDT16180 Manual

RECHARGING BATTERIES

NOTE: Before using the tool, read
the instruction book carefully.
1. BEFORE USING YOUR CORDLESS
DRILL
Your battery pack is UNCHARGED and
you must charge once before use. Your
battery pack will not be fully charged
until you have performed several charge
and discharge operations by charging
& working with your drill. After this your
battery pack performance will improve.
WARNING: The charger and
battery pack are specifically
designed to work together so do not
attempt to use any other devices. Never
insert or allow metallic objects into your
charger or battery pack connections
because an electrical failure and hazard
will occur.
2. HOW TO CHARGE YOUR BATTERY
PACK (SEE A & B)
In a warm environment or after heavy use,
the battery pack may become too hot,
in order to prolong the battery life, you'd
better allow time for the battery to cool
down before recharging.
When the battery is charged for the first
time and after prolonged storage, the
battery will only accept approximately 60%
charge. However, after several charge and
discharge cycles the battery will accept a
100% charge.
Insert the charger plug (b) into a suitable
mains socket. The power indicator (red) (d)
will illuminate.
Insert the battery pack(8) into the charging
base(a), the charging indicator (green) (c)
will illuminate. The green and red light will
stay on charging.
Note:
If the green light does not light immediately
when a battery is inserted, which has just
been used, remove the battery and insert
again after a few minutes.
8
A fully discharged battery will take
approximately 3-5 hours to reach full
charge. When charging is complete,
unplug the charging plug from the wall
socket.
The charger will not automatically switch
off when the battery is fully charged, and
the power indicator (red) and the charging
indicator (green) will remain on. Do not
leave your battery on charge continuously.
This may damage the battery cells.
3. TO REMOVE OR INSTALL BATTERY
PACK
Locate latches on side of battery pack and
depress both sides to release battery pack
from your drill. Remove battery pack from
your drill. After recharge insert the battery
pack into drill's battery port. A simple push
and slight pressure will be sufficient.
OPERATION INSTRUCTIONS
1. ON/OFF SWITCH
Depress to start and release to stop your
drill.
HELPLINE NO 08707252949
WARNING:
Fig.A
Fig.B