Table of Contents
Advertisement
BEFORE OPERATION
Remove the paper strip bin.
Adjust the paper guides according to the paper width.
Hold down the tabs on the adjustable paper guides and slide them in or out.
•
Make sure to set the adjustable paper guides to the size of the paper width. When they are not positioned
properly, a malfunction such as paper jam and misaligned printing position may occur.
•
The printer can print papers with different width (5" (127 mm) and 6" (152 mm)). When printing a 5"-wide paper
first and then a 6"-wide paper, streaks may appear on the printed image half an inch from the edges. It is
recommended to use either 5"-wide or 6"-wide papers, but not both with the same printer.
Install the print paper into the unit and remove
the sticker.
Place the printing paper in the correct orientation.
Make sure the paper roll is firmly installed.
•
Do not press or lean down while the printing unit
is open. The printer may fall and cause damage or
injury if a downward force is placed on the printing
unit while it is open.
•
Make sure to turn on the power before installing the
print paper. Otherwise, a paper jam may occur.
•
Load the paper roll slowly into the unit. If it is
dropped along the ditches, the unit or accessories
may be damaged.
PRINT PAPER INSTALLATION
6"
CAUTION
NOTE
5"
5"
NOTE
CAUTION
6"
Direction of paper insertion
11
Advertisement
Table of Contents
