Installation Of Print Paper - Mitsubishi Electric CP-D70DW Operation Manual

BEFORE OPERATION

INSTALLATION OF PRINT PAPER

Spacers
For the usage of the spacers, see the Quick Setup Guide.
How to attach the spacers
1. Attach the spacer with the paper flange's stoppers retracted.
2. Turn the spacer until the latches are locked.
When you remove the spacers from the paper flanges, follow the
above procedure in reverse.
Attach the supplied paper flanges to both sides of the print
paper.
When you pinch the latches on the paper flange, the stoppers retract into the shaft.
Attach the flanges to the print paper with the stoppers retracted.
Make sure that the flanges are attached to the print paper securely, and release the
latches.
• Take care not to pinch your fingers.
• Do not remove the sticker on the print paper yet.
• Do not slacken the paper. Any slack in the print paper may degrade the print
quality.
• When placing the print paper, keep the print paper upright.
• When you put the print paper sideways, it may roll and fall. This may cause injury.
• Fingerprints or dust on the paper's surface may degrade print quality and cause
paper jams.
NOTE
CAUTION
NOTE
Paper
flange
Spacer
Latch
INCORRECT CORRECT
Sticker
11