Before Calling For Service; Instructions For Transportation - Mitsubishi Electric CP-M15 Operation Manual

ERROR MESSAGES AND COUNTERMEASURES

For the following symptoms, check the unit again before calling for service.
Symptom
The power is not turned on.
The printing unit doesn't open.
The image is not printed.
An error can not be resolved.
When transporting this unit for some reason such as repair, follow the instructions below.
1. Use the original packaging.
The genuine package unit may not endure more than one round trip. If the unit is transported with the package unit more
than one round trip, it may not be guaranteed.
Purchase another package unit when transporting this unit again.
Pack the unit with the accessories (ink ribbon and print paper) removed.
2. Close the printing unit firmly.
When closing the printing unit, push it until a click is heard.
• When the printing unit is not closed completely or the latch bar is accidentally pressed, the printing unit may open.
It can cause injury or damage.
3. If the ink ribbon or print paper are stuck and can not be taken out, please consult your dealer
or technical support. Additional damage may occur if you force the media out or use a foreign
tool to remove it.

BEFORE CALLING FOR SERVICE

Is the power cord plug disconnected from the outlet?
→ Connect the power cord plug to the outlet firmly.
→ The protective circuit may be working. Turn off the power and wait for
about two minutes. Then turn on the power again.
Are you turning off the power during printing procedure?
→ Turn on the power and then open the printing unit.
Is the PAPER/RIBBON indicator or the ALARM indicator illuminating or
blinking?
→ Refer to "Overcoming paper jams."
Is the appropriate size of data sent to this unit?
→ Make sure that the appropriate size of image data is sent to this unit.
Is the print paper or the ink ribbon used up?
→ Check them.
Is the printing unit set firmly?
→ Set the printing unit firmly.
→ When the indicators keep illuminating or blinking though the above
operations are performed, remove the ink ribbon and print paper and
reinstall them.
→ Turn off the power by pressing and holding the POWER button for
two seconds or longer, and then turn it back on by pressing the power
button. This printer starts initialization.

INSTRUCTIONS FOR TRANSPORTATION

Check & Remedy
POWER button
CAUTION
18