Table of Contents
Advertisement
BEFORE OPERATION
Spacers
See the Quick Setup Guide on how to use the spacers.
How to attach the spacers
1. Insert the spacer with the paper flange's stoppers retracted.
2. Turn the spacer until the latches are locked.
When you remove the spacers from the paper flanges, follow the above
procedure in reverse.
Attach the supplied paper flanges to both sides of the print
paper.
When you pinch the latches on the paper flange, the stoppers retract into the shaft.
Attach the flanges to the print paper with the stoppers retracted.
Make sure that the flanges are attached to the print paper securely, and release the
latches.
•
Take care not to pinch your fingers.
•
Do not remove the sticker on the print paper roll yet.
•
Do not loosen the paper roll. Any slack in the print paper may degrade
the print quality.
•
When placing the print paper, keep the print paper upright.
•
When you put the print paper sideways, it may roll and fall. This may
cause injury.
•
Fingerprints or dust on the paper's surface may degrade print quality and
cause paper jams.
•
When the paper flange cannot be attached due to the deformation of the
print paper, reshape the print paper manually before attaching the flange.
Press the POWER switch on the right side panel to turn on the
power.
PRINT PAPER INSTALLATION
NOTE
CAUTION
NOTE
NOTE
Spacer
Latch
INCORRECT
CORRECT
POWER switch
Paper
flange
Sticker
11
Hide quick links:
Advertisement
Table of Contents
