Before Operation; Installation Of Print Paper - Mitsubishi Electric CP9600DW Operation Manual

BEFORE OPERATION

Before printing,
1 Install the print paper to this unit. (See below.) 1 1 1 1
2 2 2
2 2
Install the ink ribbon to this unit. (See page 13-14.)

INSTALLATION OF PRINT PAPER

Spacers
2 The spacers are attached to the paper flanges. For the necessity of
the spacers, see the Quick Setup Guide.
Remove the cushions put between the paper flange and spacer when
use them.
How to attach and remove the spacers
1. Turn the spacer until the latches are unlocked.
2. Remove the spacer with the paper flange's stoppers retracted.
When you use the print paper with which the spacers have to be
used, attach the spacers to the paper flanges by reversing the above-
mentioned removal procedure as shown right.
1 1 Attach the supplied paper flanges to both sides of the print paper. 1 1 1
When you pinch the latches on the paper flange, the stoppers retract into the shaft.
Attach the flanges to the print paper with the stoppers retracted.
Make sure that the flanges are attached to the print paper securely, and release the
latches.
• Take care not to pinch your fingers.
• Do not remove the sticker on the print paper yet.
• Do not slacken the paper. Any slack in the print paper may degrade the print quality.
• When placing the print paper, remove one flange and keep the print paper upright
on its side with no flange.
• When you put the print paper sideways, it may roll and fall. This may cause injury.
Do not touch the thermal head.
Fingerprints or dust on the thermal head will degrade the print quality.
NOTE
CAUTION
NOTE
latches
Spacer
Paper
flange
Sticker
INCORRECT CORRECT
11