Table of Contents
Advertisement
BEFORE OPERATION
Insert the print paper edge to load the paper as illustrated. Stop
feeding the paper roll when the paper-feed status light turns
GREEN.
When no paper is fed, the paper-feed status light blinks slowly in red.
Make sure to insert the paper straight.
•
When taking the print paper out, pull it up toward you by holding the
paper flanges.
•
Make sure to turn on the power before replacing the print paper.
•
Make sure to eliminate any slack from the print paper. If you carry out
the following steps without eliminating the slack, the print paper may be
damaged.
•
Do not over feed paper. Doing so may cause a paper jam.
Attach the paper strip bin.
Hold the door down and slide the print unit in without pressing
the latch bar on top of the door.
When a new paper is loaded and the printing unit is closed with the power turned
on, the paper will be automatically fed and cut.
•
Do not press or lean down while the door is open. The printer may fall
and cause damage or injury if a downward force is placed on the door
while it is open.
•
When closing the printing unit, be careful not to get your hands caught
between the printer and the printing unit or between the door and the
paper strip bin. Otherwise, you may get injured.
•
When closing the printing unit, push it until a click is heard.
•
If the PAPER/RIBBON indicator flashes with the printing unit closed, the
print paper may have been installed incorrectly. In this case, open the
printing unit to make sure that the print paper has been installed correctly.
Then close the printing unit again.
•
When the paper roll is reinstalled more than three times, the print paper
may be used up earlier than the ink ribbon.
Installation of ink ribbon and print paper is complete.
•
Make sure to replace the ink ribbon and the print paper simultaneously.
•
Empty the paper strip bin frequently to prevent jamming the strips at the
print outlet. Whenever you replace the ink ribbon and the print paper,
make sure to throw away the paper strips in the paper strip bin.
•
Whenever you replace the ink ribbon and the print paper, clean the
thermal head and the platen roller. For the cleaning procedures,
"CLEANING" (on pages 19 and 20).
NOTE
NOTE
CAUTION
NOTE
NOTE
Paper-feed
status light
see
Red
Green
12
Advertisement
Table of Contents
