Print Paper Installation - Mitsubishi Electric CP-W5000DW Operation Manual

BEFORE OPERATION
• Do not push down on the slide door. If you push down on the slide door when they are open, this printer may fall and
it can cause damage or injury.
Attach the supplied paper flanges to both sides of the print
paper.
Hold the latches of the paper flange with gear, align the projections of the paper
flange with the indentations in the print paper core, and then insert the paper flange
into the print paper. Make sure that there is no clearance between the paper flange
and the print paper.
Next, hold the latches of the paper flange without gear and insert it into the opposite
side of the print paper.
• Take care not to pinch your fingers.
• Do not remove the sticker on the print paper roll yet.
• Do not remove the barcode label.
• Do not loosen the paper roll. Any slack in the print paper may degrade
the print quality.
• When placing the print paper, keep the print paper upright.
• When you put the print paper sideways, it may roll and fall. This may cause
injury.
• Fingerprints or dust on the paper's surface may degrade print quality and
cause paper jams.
Open the front cover bin toward you by its handle. Lift and
remove the front cover bin.
Get rid of paper strips from the front cover bin.
• Do not pull the front cover bin forcefully because it may be locked. In
such a case, make sure that the printer power is on and then hold down
the ENTER button on the operator control panel for a while to unlock the
bin.
• The front cover bin gets heavy as paper strips accumulate. When
removing the front cover bin, be careful not to drop it.
Install the print paper into the printer so that the paper flange
with gear comes to the left.
Make sure the print paper is firmly installed.
• Load the print paper slowly into the printer. If it is dropped inside the
printer, the printer or accessories may be damaged.

PRINT PAPER INSTALLATION

NOTE
NOTE
CAUTION
NOTE
NOTE
CAUTION
NOTE
Projections
Indentations
Barcode
Sticker
label
INCORRECT CORRECT
Handle
12