BROSA Parc Dresser Assembly Manual

Advertisement

v1.0
ASSEMBLY GUIDE
Parc Dresser

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Parc Dresser and is the answer not in the manual?

Questions and answers

Summary of Contents for BROSA Parc Dresser

  • Page 1 ASSEMBLY GUIDE Parc Dresser...
  • Page 2 Components Upon unpacking your dresser from it’s delivery box, you should have the separate pieces shown below. Follow the steps on the next pages to assemble your new dresser. Dresser x 1 Leg x 4 Hardware What you need A x 8 B x 8 C x 6 Spec: 5/16 x 60mm...
  • Page 3 Align a leg to the underside of the dresser Step 1 that the screw holes are overlapping. Fit a washer to a bolt and screw into a hole and repeat for the other bolt to secure the leg in place. Repeat process for the remaining legs and use the allen key tighten all of the bolts (A).
  • Page 4 Align a strap to the back of the dresser and secure Step 3 in place with a screw (F). Repeat for the other strap (H). F x 2 H x 2 At the location where the dresser will be placed, Step 4 mark out two holes along the wall where you’ll secure the straps.
  • Page 5 e dresser is 100cm wide by 93cm high and 47cm Step 5 deep and can take up to 60kg maximum weight on top and 5kg inside each draw. Enjoy your new dresser! 60KG...

Table of Contents