Table of Contents
Advertisement
Setup
For box contents, please refer to the printed contents sheet or setup manual provided in the box.
The accessories included depends on the location where the monitor was shipped.
To attach the base stand to the monitor standN
1. Place monitor face down on a non-abrasive surface (Figure 1).
2. Please rotate the monitor stand 90 degrees as shown in Figure 1.
CAUTIOON
Please refer to
3. Attach the base stand to the monitor stand, then tighten the screw at the
base stand's bottom (Figure 2).
OOTEN
Reverse this procedure if you need to re-pack the monitor.
AROIONN
Please refer to
To connect the monitor to your system, follow these instructionsN
OOTEN:
Make sure to read
"Important Information" on page 3
1. Turn off the power to your computer.
2. Place your hands on each side of the monitor to tilt the panel to a maximum tilt angle and lift up to the highest position
(Figure 3).
"CAUTION
5".
"WARNING
8".
before installation.
Figure 3
English−17
90°
Figure 1
Maximum Tilt
Screw
Figure 2
Advertisement
Table of Contents
