Table of Contents
Advertisement
Electronic programmer/timer
This oven's timer is equipped with touch control sensors. Each
registered touch of a sensor is confirmed by a beep. It is advisable to
keep the sensors clean at all times to avoid errors in operation.
Setting the current time
After connection to the mains supply, or re-connection after a power
outage, the display will show 'Choose time format: 24hr'. Use the
and
sensors to change between 24 and 12 hour time display. Press
once the desired format is selected.
•
Use the
•
Use the
Please note:
•
The time must be set for the oven to work.
•
You can follow the above steps for changing the time. Firstly
though, the oven must be on but not running a function and you
must touch and hold the clock sensor
Setting the minute minder function
The minute minder function can be set at any time whilst a function is
active. The minute minder can be set anywhere from 1 minute to 23
hours and 59 minutes.
•
Press the timer sensor
flash and the time display should show '00:00'.
•
Set the desired duration of the minute minder using the
sensors. Touch the timer sensor
set. If a function is active, then you may have to cycle past the
and
symbols using the timer sensor
16
and
sensors to set the number of hours. Press
and
sensors to set the time in minutes. Press
. The
to enter time adjustment.
symbol on the display should
and the minute minder will be
.
.
.
and
Advertisement
Table of Contents
