Removal And Installation; Removal - Isuzu 4JA1 Workshop Manual

Read this section carefully before performing any removal and installation procedure. This section gives
you important points as well as the order of operation. Be sure that you understand everything in this section before
you begin.

REMOVAL AND INSTALLATION

Removal

1. Battery
1) Disconnect the battery cable and the grounding cable
2) Remove the battery clamp. Take care not to
3) Remove the battery.
4) Disconnect the battery cable at the starter motor and
P1010011
2. Engine Hood
Apply setting marks to the engine hood and the engine
hood hinges before removing the engine hood. This will
facilitate reinstallation of the engine hood to its original
position.
P1010002
3. Supporting the Vehicle
1) Jack up the vehicle.
2) Place chassis stands at the front and the rear of the
F06R300006
4. Under cover (for 4x4 model)
5. Rear propeller shaft
1) Remove the propeller shaft flange yoke at the rear
2) Remove the center bearing retainer bolts.
3) Remove the propeller shaft together with the center
ENGINE MECHANICAL 6A – 37
from the battery terminals.
accidentally short the battery with the wrench or some
other tool.
the ground cable at the cylinder body.
vehicle.
differential.
bearing from the transmission mainshaft spline.