Generator; Removal And Installation - Isuzu 4JA1 Workshop Manual

Read this Section carefully before performing any removal and installation procedure. This Section gives you
important points as well as the order of operation. Be sure that you understand everything in this Section before you
begin.

GENERATOR

REMOVAL AND INSTALLATION

Important Operations-Removal
Cooling Fan Belt
1. Disconnect the battery cables at the battery terminals.
2. Loosen and remove the fan belt adjusting plate bolts.
3. Remove the fan belt from the generator drive pulley.
Generator
P1010002
1. Remove the vacuum pump hose.
2. Remove the generator bolt and the generator from the
bracket.
Important Operations-Installation
Follow the removal procedure in the reverse order to
perform the installation procedure. Pay careful attention to
the important points during the installation procedure.
Generator
1. Install the generator to the bracket.
2. Tighten the generator bolt to the specified torque.
3. Install the vacuum pump hose.
Generator Bolt Torque
ENGINE ELECTRICAL 6D – 7
N m (kg m/Ib ft)
40 (4.1/30)