6H – 6 ACCELERATOR CONTROL
Removal
1. Disconnect the accelerator control cable from the
2. Remove the cable clips.
3. Remove the accelerator control cable from accelerator
4. Remove the accelerator control cable from the throttle.
Inspection
Check the following items and replace the control cable if
any abnormality is found.
RTW46HMH000201
Installation
1. Install the accelerator control cable to accelerator
2. Install the accelerator control cable to throttle.
3. Install accelerator control cable to accelerator bracket.
4. Install the cable clips to accelerator control cable.
NOTE:
Confirm that the throttle (engine side) is at full stroke
when the accelerator pedal is at full stroke.
accelerator pedal and dash panel.
control cable bracket.
1) Slide the lock in direction A
2) Rotate the ratchet ring in undirection an arrow 90°.
•
The control cable should move smoothly.
•
The control cable should not be bent or kinked.
•
The control cable should not be damage or
corrosion.
control pedal dash panel.
Attach T-END and inner cable to throttle cam of
engine.
1) Rotate the ratchet ring in direction an arrow 90°
until both white marking are aligned.
2) Confirm marking of outer cap must be upper side.
3) Slider the lock in direction B.
4) Confirm ratchet ring is locked.