Advertisement
Intellect Wave
Chair & Desk Frame
®
Repair & Replacement Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Heel Glide Removal & Installation
1. Tip the frame down onto a soft
protective surface to access the heel
glide as illustrated in figure 1.
2. Using a drill driver with a #2 Phillips
bit, remove the screw securing the
heel glide, then remove the glide
from the heel plate (Figure 2 & 3).
Note: The two new heel glides are
different, and are represented left- or
right-hand based on the location
of the screw hole used to attach
the glide to the steel heel plate.
Screw holes must face each other
under the chair. If heel glides are
not installed to the proper left- or
right-hand location, disassembly and
reassembly will be required.
3. Place a new heel glide into position
on the steel heel plate. Align the
mounting hole of the glide with
the hole on the steel heel plate and
secure glide to steel plate using one
#8-32 x
/
" Phillips flat head screw
1
2
with thread-lock patch provided.
Tighten the screw such that the head
of the screw is flush with the surface
of the heel glide (Figure 4).
1330 Bellevue Street • P .O. Box 8100 • Green Bay, WI 54308-8100 • Tel 1-800-424-2432 • www.ki.com
Figure 1
heel
glide
steel heel
plate
steel heel
Intellect
Wave Chair
Figure 3
© 2018 Krueger International, Inc. All Rights Reserved • Code KI-RR-000006/KI/PDF/0218
Intellect
Wave Chair
heel
glide
plate
heel
glide
#8-32 x / "
1
2
screws
Intellect
Wave Chair
Figure 2
right-hand
#8-32 x / "
heel glide
steel
steel heel
heel plate
plate
Intellect
Wave Chair
Figure 4
heel
glide
1
2
screws
left-hand
heel glide
Advertisement
