Table of Contents
Advertisement
R1048 • Owner's Manual
Motor Capacitor Installation
WARNING:
Disconnect the power plug before servicing the motor
Locate the aluminum housing on the side of
1.
the motor body.
2.
Using a phillip/cross screw driver to remove
the two screws to open the capacitor housing
cover.
3.
Pull the capacitor out and remove the two
wire caps to disconnect the wires.
4.
Replace the old capacitor with the new
capacitor and reattach the wires using the
same wire caps.
5.
Close the capacitor cover and make sure the
rubber gasket is properly in place so no
water can seep into the housing.
Side Table & Splash Guard Installation
Install the side table and splash guard as shown in the
illustration to the side. Fasten the knobs/screws
respectively to the saw frame.
9
Advertisement
Table of Contents
