Table of Contents
Advertisement
M1036 • Owner's Manual
Preparation for Use
BLADE INSTALLATION
1.
Turn the silver knob on the inner blade guard
counterclockwise until it pops out to unlock the
blade guard. (see figure 3)
2.
Slide the outer blade guard horizontally across the
inner blade guard towards the plunge handle. The
tab at the rear of the blade guard must clear the
enclosing slot.
3.
Rotate the blade guard away so that it lays open.
Do not separate the outer guard from the inner
guard!
4.
Remove the blade shaft nut and outer flange. If a
blade has been mounted, hold the blade with one
hand or use the provided hex wrench to insert into
the slot on the blade shaft and use the other hand
to loosen the nut with the universal wrench.
Remove existing blade.
5.
Mount new blade, but make certain the arrow on
the blade coincides with the rotation direction of the
shaft.
OPERATING THE WATER SPRAY SYSTEM
1.
Open outer blade guard.
2.
Locate the adjustable water nozzle on the outer
and inner blade guard. (see figure 4)
3.
Using figure 4 on right as reference set the water
nozzle to desired effect (minimal mist/max water).
4.
Note that the blade has to be removed in order to
adjust nozzle on the inner blade guard.
7
Silver knob
fi gure 3
Inner blade guard
Outer blade guard
Max Water
Water sprayed in this
direction has maximum
water saturation on blade
but causes more water loss
fi gure 4
Turn adjustable
nozzle using
Minimal Mist
plier
Water sprayed in this
direction has minimal
misting while cutting for
cleaner work environment
Adjustable water nozzle
Blade
Advertisement
Table of Contents
