Table of Contents
Advertisement
Saw Maintenance
WARNING:
For your safety, before performing any maintenance on the saw turn
off the power switch and unplug the power cord.
GENERAL RULES
-
Always clean the machine before maintenance/repair.
Before cleaning/maintaining/repairing the machine, the
-
machine must be turned off and unplugged.
Steps to Follow When Cleaning the Saw
Please do not use aggressive cleaners (i.e. containing solvents).
1.
Do not use high-pressure water jets, aggressive detergents or
solutions and liquids with a temperature exceeding 86 F! Use
fluff-free cloth only.
Use a cloth which may be lightly moistened only for removing dust
2.
and dirt. Hard packed dirt can be removed with a soft brush.
For the sake of safety, water/cleaning liquid/vapor may penetrate
3.
into the electric motor, connectors/plugs, switches, etc. therefore
cover/seal all aperatures, holes in the housing, connectors, plugs,
with adhesive tape.
4.
Use a soft, low-pressure water jet and a brush to rinse dirt and
incrustations away. Be particularly careful when near hazardous
parts of the machine (i.e. switch, motor, etc...). Clean the vulner-
able parts with a moist fluff-free cloth.
Do not "rinse" the bearings of the drive elements to prevent them
5.
from running dry. The ball bearings of the machine are permanently
lubricated.
After cleaning, remove all areas that were covered/seal by tape! All
6.
screws/nuts which you may have loosened must be tightened
again!
After wet cleaning, plug the machine to a power outlet which is
7.
equipped with a ground fault current interrupt. If the device cuts
power, the machine must be inspected by an authorized dealer
prior to use!
18
Advertisement
Table of Contents
