Unpack, Assembly; Set-Up - Sawmaster R1048 Owner's Manual

R1048 • Owner's Manual
Unpacking
Open the carton box cover by lifting the
top portion. Locate the accessory box and
check its content for the following items
before discarding any packaging:
• Saw
• Pin (2)
• Universal Wrench
• Water Pump
• Wheel Assemblies (2)
• Owner's Manual
• Drain Plug
• Rear Splash Guard
• Wing Screw
• Extension Table
• Knobs (2)
• Lifting handles (2)
• Masonry guide
• Bucket
Proceed to the following section to
complete assembly of the saw.
Assembly & Set-up
1. Remove the carton box cover by lifting the upper cover.
2. Locate the accessory box and open it. Obtain the two
lifting handles and install one on each end of the saw.
Install it in the side furthest from the post.
3. Loosen the lock knob on top of the cutting head.
4. Deploy the stand legs by following the "folded leg
assembly" section.
5. Install the side extension table, side splash guard and
back splash guard.
6. Install the spring holder on top of the sliding rail to hold
the power cable and the water hose.
7. Fill the tray with water before operating the saw.
5