Troubleshooting - Sawmaster R1048 Owner's Manual

Troubleshooting

Problem
Machine does not run when switched
on
Motor stops (power cut out)
Poor machine performance, little
power
Possible Cause
Power cord not properly fixed/
plugged in
Power cord defective
Main power switch defective
Loose electrical connection inside
the electric system
Motor defective
Too much pressure exerted while
cutting
Incorrect specification for saw blade
Saw has a defective electric system
Power cord/extension cable too long
or cable still wound up inside cable
drum
Power network is insufficient
Drive motor no longer runs at rated
speed (RPM)
Solution
Check that the machine is properly
connected to the power supply
Have the power cord checked, re-
place if necessary
Have the main power switch checked
and replace if necessary by a quali-
fied electrician
Have the whole electric system of
the machine checked by a qualified
electrician
Have the motor checked and re-
placed if necessary by a qualified
technician
Exert less pressure when cutting
Use a saw blade which corresponds
to the material being cut
Have the electric system of the saw
checked by a qualified technician
Use a power cord/extension cable of
the rated length, use a cable drum
with cable fully extended
Observe the electrical ratings of the
machine and connect it only to a
power network which complies with
these ratings
Have the motor checked by a quali-
fied electrician and have it replaced if
necessary
24