Table of Contents
Advertisement
WARNING:
For your safety, before performing any maintenance on the saw turn
off the power switch and unplug the power cord.
Before & After A Prolonged Time
Before not using the
machine for a prolonged
period of time
After not using the
machine for a prolonged
period of time
Temperature Changes
Ambient Temperature
Below 37 F (Winter)
-
Clean and lubricate all movable parts. DO NOT
GREASE the GUIDE RAILS.
-
Check that the legs are safely fixed.
-
Check that all screw and nut points are tightened
correctly.
-
Check that the roller table is rolling on the rails and that
it moves securely back and forth. With the saw blade
removed, switch on the motor for an instant and switch it
off again. If the motor does not run, have the machine
inspected by a qualified electrician.
-
Check that the immersion pump works properly. Turn
on the valve if applicable and switch the machine on. If
the pump does not give any water or only a little, switch
the machine off at once. Clean the pump, or replace it if
necessary.
-
To prevent the water in the pump and cooling system
from freezing, remove the water after using the machine
or when there will be a long break. Make sure that the
cooling system is entirely drained so that there is no
water left inside the pump, the bearing house and the
water hose!
20
Advertisement
Table of Contents
