Sawmaster R1048 Owner's Manual page 27

Problem
Saw blade is blunt
Appearance of cut is not optimal
The center hole in the saw blade has
become wider due to wear
Saw blade shows blooming colors
Grinding marks on the saw blade
Possible Cause
Saw blade type is unsuitable for the
material being cut
Saw blade type is unsuitable for the
machine performance
Saw blade too hard
Diamond segments are blunt
Poor tension in the blade material
Too much load placed on the saw
blade
Diamond segments are blunt
The saw blade has slipped on the
motor shaft when running
Saw blade overheating due to a lack
of cooling water
Lateral friction when cutting
Material is not being fed parallel to
the saw blade
Poor tension in the blade material
Too much load on the saw blade
Solution
Use appropriate type of saw blade
Sharpen the diamond saw blade
Return the saw blade to the manu-
facturer
Use a suitable saw blade
Sharpen the saw blade
The arbor of the saw blade must be
fitted with an appropriate adaptor
ring
Check the receiving flange and have
it replaced if necessary
Ensure an optimum flow of cooling
water
The material feed is too high; pro-
ceed more slowly
Ensure that the direction of feed is
absolutely parallel to the saw blade
Adjust the roller table or have it
adjusted
Have the saw blade tensioned
The material feed is too high, pro-
ceed more slowly
26