Commissioning - Stuart Turner Monsoon S2.0 bar Single Installation, Operation & Maintenance Instructions Manual

9 COMMISSION IN G
System Flushing: This pump incorporates push-in connectors and plastic
components that must not come into contact with solder flux, acid-based
descalents or aggressive cleaning agents. The pipework system should be
flushed out prior to the pump being connected to ensure any
contaminants/chemical residues and foreign bodies are removed from
elsewhere in the system.
Water Supply: Always ensure that water storage capacity is adequate to meet the
demand. Ensure the pump chamber is full of water before starting the pump.
Failure to do this could result in seal damage. To ensure dry running does not
occur the pump must be primed as described in priming section below. Do not
run pump dry.
9.1 Priming
Never operate pump with inlet and/or outlet isolating valves in the
closed position. Damage will occur!
The pump must be primed (filled with water) before starting.
Turn on water supply from the system service valves, prime and vent the pump by
opening the pump inlet and outlet isolating valves to allow pump to fill and vent.
In the case of twin pumps, both pump chambers must be independently primed.
9.2 Starting
1. Switch on power and open terminal fitting. Pump should start.
2. Open and close all outlets in turn associated with the pump, (including w/c
systems) allowing water to flow from each outlet until all air is purged. As
each outlet is opened and closed, the pump will start and stop
respectively.
3. The tap or control valve within the system when opened and closed will
now turn the pump on/off. If this is confirmed to be the case, the system is
now operating correctly.
4. Carefully check pump and pipework for leaks whilst pump running and
stationary before leaving the installation unattended.
For Further Technical Support: Phone the Stuart Turner TechAssist team on
+44 (0) 800 31 969 80. Our staff are trained to help and advise you over the phone.
24