Operation And Display Panel - Turbo Air MUR-20S-N6 Installation And Operation Manual

OPERATION AND DISPLAY PANEL

Model: MUR-20S-N6
MUR-24S-N6
MUR-27S-N6
1. INTRODUCTION OF KEY FUNCTION
Button name
Set parameters
Set
Switch between menu and parameters
Adjust menu and parameters
Turn on/off light
Upload parameters to the copy card
Adjust menu and parameters
Download parameters to the copy card
View the temperature value of evaporator sensor
Exit setting parameters
Rst
Force defrost to start defrost
2. TEMPERATURE CONTROL
1) Default downtime temperature 39°F, boot temperature 47°F
2) Temperature adjustment, long press SET key for 3 seconds, enter the user
menu, display SET, press SET key again to display ST parameter value, at this time, you can
operate or modify the temperature setting value. When ST is displayed, PO is displayed by
pressing the key
ness can be automatically verified by
When password is verified, ST and C1, C5, C6 can be selected by
shutdown temperature and start-up temperature, and set the temperature range. After selecting
the menu item, press the set key to enter the current parameter setting, press
the parameter value, and then press the set key to return to the menu selection.
3) Under any parameter setting, pressing the
the parameter setting and automatically saves the current parameter value.
MUR-34S-N6
MUR-20SG-N6
MWR-20S-N6
Set
Rst
Function
and 00 is displayed by pressing the key set. At this time, password correct
or
MWR-24S-N6
MWR-27S-N6
MWR-34S-N6
Press if for 3 sec.
Press it and the controller responds.
Press if and the controller responds.
Press if and the controller responds.
Press it for 3 sec.
Press if and the controller responds.
Press it for 3 sec.
Press if and the controller responds.
Press if and the controller responds.
Press it for 3 sec.
input controller administrator password 55.
key or 30 seconds keyless operation exists
Rst
13
Action
or key to adjust the
or to adjust