Display Panels - Turbo Air JUR-44D-N Installation And Operation Manual

DISPLAY PANEL OF REFRIGERATOR AND FREEZER
BASIC OPERATION
1. Plug in and turn on the power switch located on the top side of the unit front cover.
The display panel will be lighted and make a beep sound. The compressor will
begin to run.
2. The default temperature setting is No. "4".
3. The compressor is automatically cycled by the electronic controller (PCB).
4. The defrost cycle is automatically controlled by the PCB.
5. Set level toward "1" for higher temperature and "8" for lower temperatures.
6. Good air flow in refrigerator unit is critical.
Be careful to load product so that it neither presses against the back wall, nor
reaches within four inches from the evaporator compartment.
- By pushing the up/down button, you can set the inside temperature.
- If you want lower temperature push the down button to be lighted lower level numbers.
FAN
EVA FAN
INDICATOR
FAN
EVA FAN
INDICATOR
- When the inside temperature is lower than -49ºF (-45ºC), the panel will display '
and higher than 64.4ºF (18ºC), the panel wil display '
Current Setting
TEMPERATURE
TEMP. CONTROL
BUTTON
Current Setting
TEMPERATURE
TEMP. CONTROL
BUTTON
REFRIGERATOR
MEAT BUTTON
MEAT
FREEZER
TURBO FREEZE
TURBO FREEZE
'.
14
TEMP.
SETTING
TEMP.
SETTING
'