B Recalling Memory In 7D Mode; Clear Measurements From Memory; Blood Pressure Assessment Indicator - BIOS Diagnostics PROTOCOL BD352 Instruction Manual

Table of Contents

Advertisement

3.9B Recalling Memory in 7d Mode

First select 7d Mode, with the unit off press the MEM button.
A. If the Protocol was done correctly, the monitor will display "
saved in the memory, and then display the Average Measurement as per the Protocol software. In the Average
Measurement screen the date will display the second day the Protocol measurements were started and then
change to the 7th day the Protocol measurements ended.
For example: If the first day of measurements are started on October 10th and ends 7 days later on October 17th, the
date will appear as 10
M
the Protocol disregards the first day of measurements and averages the last 6 days of measurements, see section 3.4
for more explanation.
Press the "MEM" button to display the subsequent measurements.
B. If the Protocol was done incorrectly or if any measurements were missed, the monitor will display "
"
" then the average measurement and then display the subsequent measurements.
Reasons why the Protocol Software is displaying
- Not enough measurements have been saved in memory. For the Protocol Software to work there needs to be 28
measurements saved in memory, 4 measurements taken for 7 days.

3.10 Clear Measurements From Memory

If you are sure that you want to permanently remove all stored memories, first choose the mode you want to delete
the memory from, then press the SET button 9 times until "
until "
" flashes 3 times to clear the memory. After this, press the "MEM" button, the symbols "
appear on the screen. This means that the memory has successfully cleared.

3.11 Blood Pressure Assessment Indicator

The bars on the left hand side of the display show you the range within which the indicated blood pressure values lie.
Depending on the height of the bar, the readout value is either within the normal (green), borderline (yellow) or danger
(red) range.
11
then change to 10
D
M
", meaning all 28 measurements have been
17
and back and forth . 10
D
:
" appears when the power is off. Press the ST button
11
will display instead of 10
M
D
10
because
M
D
" then
" and "
" will

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PROTOCOL BD352 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Protocol precision 12.0

Table of Contents