Table of Contents
Advertisement
② Selection of the sewing-end speed reduction function (Function setting No. P005)
P005
In addition, the speed limit during the sewing-end speed reduction and the number of stitch at which the
sewing-end speed reduction function starts can also be changed. (Function setting Nos. P006 - P007)
P007
P006
③ Stop-position setting (Function setting Nos. P013 - P014)
This function setting number is used for setting the needle stop position when the sewing machine stops.
P013
It is also possible to set the needle stop position after the completion of thread trimming. (Function setting
No. P014)
P014:
④ One-shot function (Function setting No. P017)
It is possible to select either the sewing machine is automatically started after the front sensor has de-
tected the material or it is started by depressing the pedal once after the front sensor has detected the
material.
P017
(Caution) This function is enabled only when
⑤ Sewing mode (Function setting Nos. P018, P020 and P026)
Function setting No. P018: Used for selecting either the sewing machine is operated under the full auto-
matic mode or under the semi-automatic mode while the "P020 Automatic sensor" is set to "1: ON".
P018
While the full automatic mode is selected,
tomatic mode is selected,
It is also possible to change the sewing mode by keeping button
pressed.
(Caution) While the full automatic mode is set selected, be aware that the sewing machine
Function setting No. 020: Used for selecting whether or not the sensor is used. If "0: OFF" is selected,
the sewing machine will be placed under the manual mode.
P020:
While the manual mode is selected,
0: Sewing-end speed reduction function OFF
1: Sewing-end speed reduction function ON
Settable range: 500 - 7000 [sti/min] <100 sti/min>
Setting range: 1 - 200 stitches
0: Lower stop position
1: Upper stop position
0: Lower stop position
1: Upper stop position
0: Automatic
1: Pedal
while the full automatic mode is selected.
Added care should be taken when you change the set value of the P017. If you
change the set value of the P017 from the initial value "1: Pedal" to "0: Automat-
ic", the sewing machine will automatically start running immediately after the
front sensor has detected the material.
Added care should be taken when you change the sewing mode to the full auto-
matic mode if the P017 is set to "0: Automatic". In this case, the sewing machine
will start sewing if the front sensor is blocked.
0: Semi-automatic
1: Full automatic
D is displayed on the operation panel.
will start sewing if the front sensor is blocked with the material or fingers. Add-
ed care should be taken while the full automatic mode is selected.
0: OFF (Manual)
1: ON (Full automatic, semi-automatic, free stitching)
E is displayed on the operation panel.
C is displayed on the operation panel
C is displayed on the operation panel. While the semi-au-
– 42 –
⑦ on the operation panel held
Advertisement
Table of Contents
