Table of Contents
Advertisement
P
ROTECTION GUARD ADJUSTMENT (FIG. 15)
1. Loosen two knobs (A) to slide protector to desired
height.
PERIODICAL MAINTENANCE
Experienced technician should be contacted when the ball
bearings
• Spindle must always be cleaned properly and with care, with the
use of compressed air jet.
• Make sure never to apply oil to the belts and the pulleys, clean
with a dry soft rag to clean when greased or dirty.
• V-belt must never be under excessive strain, this will cause the machine to overload and can damage
the motor bearings, spindle and belt.
FENCE ADJUSTMENT (FIG.16)
The fence is fixed the position before shipment, following the
instruction for when need to do the minor fence adjustment.
1. Loosen the screw (A) and adjust (B) set screw for adjusting
the fence to proper position then tighten screw (A). (Pic.1)
2. Loosen the screw (A) and adjust (D) set screw for adjusting
the fence to proper position then tighten screw (A). (Pic.2)
1. Loosen the screw (A) and adjust (E) set screw for adjusting
the fence to proper position then tighten screw (A). (Pic.3)
2. Loosen the screw (A) and adjust (C) set screw for adjusting
the fence to proper position then tighten screw (A). (Pic.4)
Improper position
fence
bracket
bracket
MACHINE LEVELING
Shift the foot pedal (A) upward to allow the leveling
screw (B) and four leveling screws located at the four
bottoms to rest on the floor.
Shift the foot pedal (A) downward to fixing the machine.
Turn the four leveling screws by using open end
wrench for adjusting the machine leveling.
fence
FIG.15
FIG.16
E
A
B
FIG.17
A
A
D
C
B
Advertisement
Table of Contents
