Periodic Maintenance - General International 80-250 Setup & Operation Manual

PERIODIC MAINTENANCE

ALWAYS DISCONNECT THE MACHINE FROM THE POWER SOURCE BEFORE PERFORMING ANY MAINTENANCE. FAILURE
TO HEED THIS WARNING CAN LEAD TO SERIOUS PERSONAL INJURY.
To prolong the service life of your jointer/mortiser and to maintain optimum performance the following basic main-
tenance procedures should be practiced and become part of your shop routine.
Keep the unit clean - After each use wipe or vacuum off all dust or woodchips on or around the machine.
Periodically apply (as directed) General International "Top Saver" #GC-010 or similar after market surface protec-
tants to prevent rust and to protect all unpainted cast iron surfaces.
Inspect the belts regularly – To avoid potentially costly downtime, consider keeping a spare set of replacement
belts on hand for use if needed. Belts that show visible signs of wear such as cracks, fraying at the edges should be
replaced immediately.
Lubrication – All bearings are sealed and permanently lubricated and no further lubrication is required. The fence
assembly and table ways also should not be lubricated. If you should encounter a "sticking" problem, simply dis-
assemble and clear away any obstructions from the ways.
RECOMMENDED OPTIONAL ACCESSORIES FOR YOUR JOINTER
We offer a large variety of products to
help you increase productivity, accuracy
and safety when using your jointer. Here's
is but a small sampling of the accessories
that are available form your local
General International dealer.
Electronic Earmuffs
99-200
Highly efficient noise
reduction to help protect
your hearing when
operating power tools.
Jointer Push Block
80-120
Set of 2 hand paddle style
push blocks help to keep
hands clear of the cutter
heads while handling
and feeding stock through
the jointer.
Dust Collectors and
accessories
We offer a wide selection
of dust collectors and
accessories to suit virtually
all your shop needs. Dust
collectors contribute to a
cleaner healthier
workshop environment.
13